Scanners

GESTETNER DSM 730 DRIVER DOWNLOAD

February 2, 2019

Remove the rear screws [B] x2. Remove some toner from the edge of the old blade with your finger, and apply it evenly along the full length of the new blade. See Note in Bold Green above. Separate the top [E] and bottom [F] of the development unit. Make sure that the head of the stud is put in the correct position. Remove the rear shoulder screw [B] x1. Replace the cleaning blade [A] x2 Reinstallation:

Uploader: Yozshushicage
Date Added: 27 August 2016
File Size: 34.64 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 17022
Price: Free* [*Free Regsitration Required]

DSm725/730

Replace the cleaning roller [F]. Separate the top and bottom parts of the PCU. Do not spill developer on the gears or sponges. Assemble the development unit. Spread the vinyl sheet provided with the developer kit on a flat surface.

DSm/ Downloads | Ricoh Global

Replace the charge roller [E]. Remove the development roller [H] from the development unit.

Turn on the main power switch. Release the front tab [C].

New Drivers  CDC ECM USB DRIVER DOWNLOAD

Gestetner DSm Developer – 60, Pages – QuikShip Toner

The drum unit is festetner conductive. Tighten the top screw [F]. Then push down to lock the tabs on the front and rear end of the PCU. Wipe with a dry cloth after cleaning with the cotton. Remove the front screw [A] x1 5. Set the rear cover gedtetner front cover [B].

If the holes are not aligned correctly, make sure that the tabs at the front, rear, and left side of the PCU are engaged correctly. Turn on the main power switch, and close the front door. Lightly tap the top of the PCU [A] with a screwdriver at 8 locations. Install the PCU in the machine.

When the drum surface is touched or becomes dirty, wipe it with a dry cloth or gestegner it with wet cotton. Follow the cautions below when handling a PCU.

Open and close the door two more times. Remove the roller assembly [D] Springs x2, Arms x2, Rollers x2 6.

New Drivers  DW G521A DRIVER DOWNLOAD

Supplies for Gestetner DSm730 EP

Separate the top [E] and bottom [F] of the development unit. Attach the front frame pawls and front and rear [A].

To prevent toner leakage, never loosen or remove the screws shown in the illustration below. Remove the rear shoulder screw [B] x1. Release the front and rear springs [C].

Open the right cover [A] and front cover [B]. While turning the black gear [K], slowly move the pack left and right and pour half of the developer over the auger [L].

Tighten the three screws and gesretner [D]. On the number pad enter 1 0 7 4. Replace the drum [E] White clip x1 [F]. If you replaced PCU components: Continue to rotate the black gear until the developer is level.